CONTAINER of Fluid Bed Dryer are made out of
MS / SS304 / SS316 / Aluminium as per requirement. The perforated sheet
& fine wire mesh screen will be provided at the bottom for proper air
HEATING can be supplied with Electrical, Steam, Thermic Fluid or Hot Air
Electrically heated Dryer will be provided with heating element of
suitable rating having MS galvanised / Stainless steel construction. Steam
/ Thermic Fluid Radiators are made out of MS / SS Tubes with MS / SS / AL
Fins as per requirement.
CONTROL PANEL will consisting of Digital Temp. Controller, Starter for
Blower, Synchronous Timer for batch time setting, Indicating Lamps, Fuses,
Main Isolator switch etc.
The wet material is introduce in the Fluid Bed
Dryer container which is provided with air distributor perforated plate at
The Blower Mounted on the top of the unit will create induced draft and
fresh air sucked in to the system, pass through filter and heating element
(either Electrical Strip Heater, Steam / Thermic Fluid Radiator). This hot
air is then passes through powder. The powder moves up and down in the
product container which is called FLUIDISATION. Due to fluidization the heat
transfer to products and it dried very fast.
The moisture from product will carry away by the air through filter bags.
Filter bags prevent the partials escaping from the Dryer.